ECOS-Water Based Stain Block (White)

ECOS- Water Based Stain Block (White) is solvent free stain block are highly efficient and has a number of uses for concealing and blocking out difficult stain such as rusted metal, rust staining and tanning staining from hardwoods like oak and mahogany, water staining on plaster walls and ceiling from leaking roofs, gutters, cisterns and many other difficult to get rid of stains.

This product will not prevent oily or tarry stains such as those from coal fires or asphalt.
It is not good for exterior bare cast iron- Ask for advice first.
This is the preferred Primer for Steel and Bare Iron.

Preparation:

• The substrate should be look, Dry, non-dusty and non oily.
• Remove any flaking or loose materials.
• The structural issue such as efflorescence, water ingress or rising damp must be resolved beforehand and re-plastered if needs be.
• The metal rush must be removed.

Application:

Mix gently and thoroughly before used.

• Apply 1 or 2 medium coats by Brush or roller depending on the harshness of the problem, allow least 6 hours between coats.
• And the final coat should be natural white before recoating, do not thin.
• You need to Avoid Applying below 5 degrees centigrade.
• Clean the equipment and brushes with water.
• Finish with any of our standard or trim paints- if you have doubt ask for advice.
• Normally just touch dry in 1-2 hours.
Coverage:
• Varies with porosity- Approximately 10-12m2 per litre coat.
• Safe and healthy.

Avoid contact in the skin and eyes- wash off immediately with water and keep out of the reach of children.

Please use the Contact form on the right for ECOS-Water Based Stain Block (White) information and ordering.